ClickCease
BOOK ONLINE HERE & SAVE 10%
Frigidaire Washer Error Code E57

Frigidaire Washer Error Code E57

When your Frigidaire washer displays the E57 error code, it indicates a high current issue on the inverter.

To address this problem systematically, follow these steps:

  1. Unplug the Washer: Begin by disconnecting the washer from the power source to ensure safety during troubleshooting.
  2. Remove the Drive Belt: Take off the drive belt from the washer. Once removed, manually spin the motor pulley. If the pulley encounters resistance or doesn’t spin freely, it’s an indication that the drive motor might be faulty.
  3. Inspect the Drive Pulley on the Washer Tub: Rotate the large drive pulley located at the back of the washer tub. If the pulley doesn’t spin freely, it suggests a potential issue with the spin bearing. In such cases, the outer tub and spin basket may need replacement due to a failed spin bearing.
  4. Check the Spin Bearing: If the spin bearing is found to be in good condition, proceed to measure the resistance of the motor windings. A healthy motor typically exhibits a resistance reading between 4 and 6 ohms.
  5. Assess Motor Health: If the motor fails to meet the specified resistance range, it’s advisable to replace the motor. However, if the motor shows the correct resistance, the issue may lie with the speed control board.
  6. Replace the Speed Control Board: In cases where the motor is in good condition but the error persists, it’s likely that the speed control board is at fault. Consider replacing the speed control board to resolve the E57 error.

By diligently following these steps, you can identify and address the root cause of the Frigidaire Washer Error Code E57. If you encounter difficulties or need further assistance, consulting a professional technician is recommended for accurate diagnosis and resolution.