ClickCease
BOOK ONLINE HERE & SAVE 10%
Frigidaire Dishwasher overflowing

Frigidaire Dishwasher overflowing

Frigidaire Dishwasher Water Inlet Valve

The water inlet valve is an electrically-controlled valve that opens to allow water to enter the dishwasher. Depending on the model, the valve stays open either for a set length of time or until the dishwasher has enough water. However, if the water inlet valve doesn’t shut off after the dishwasher has enough water, the dishwasher will overflow. If water drips into the dishwasher when the door is open, or if water collects at the bottom of the dishwasher while it is not use, you may need to replace the water inlet valve.

Frigidaire Dishwasher Main Control Board

A dishwasher’s main control board provides power to nearly every electrical component in the dishwasher. If the control board continues to send power to the water inlet valve during the drain cycle, the dishwasher could overflow. While this is not that common of a problem, you can inspect the board for signs of burning or a shorted-out component. You can also use a multimeter to test the water inlet valve for incoming power during the dishwasher’s cycle.

Frigidaire Dishwasher Lower Wash Arm Assembly

If the lower wash arm has a crack or split on the side it can cause water to splash out the bottom of the door, giving the impression that the dishwasher is overflowing. Inspect the wash arm assembly for any damage and replace if necessary.

Wrong type or incorrect amount of detergent

Make sure to use the proper dishwasher detergent. Use the proper amount of detergent for your water hardness; too much soap in soft water can cause oversudsing and leaking.

Frigidaire Dishwasher Control Board

A dishwasher’s control board provides power to nearly every electrical component in the dishwasher. If the control board continues to send power to the water inlet valve the dishwasher could overflow. While this is not that common of a problem, you can inspect the board for signs of burning or a shorted-out component. You can also use a multimeter to test the water inlet valve for incoming power during the dishwasher’s cycle.

Frigidaire Dishwasher Float Switch

The float switch actuates in order to prevent the dishwasher from overflowing. If the float switch is defective or stuck, it might not stop the dishwasher from overflowing. If the float switch is defective, replace it.

Frigidaire Dishwasher Pressure Switch

A dishwasher pressure switch is the component that will send a signal to shut off the water inlet valve once an appropriate amount of water has entered the tank for a wash cycle. If the pressure switch is malfunctioning, it may fail to signal the inlet valve to close and cause the dishwasher to overflow. You can use a multimeter to test the pressure switch’s terminals for appropriate changes in electrical continuity before and after blowing air into the attached pressure tube. If the switch has shorted or does not test appropriately, it should be replaced.