Frigidaire Washer Error Code E56

If your Frigidaire washer is displaying Error Code E56, it indicates a high motor current.

To troubleshoot and resolve this issue, follow these steps:

1. Unplug the Washer: Start by disconnecting the washer from the power source to ensure safety during the diagnostic process.
2. Remove the Drive Belt: Take off the drive belt from the washer. This can typically be done by accessing the back of the appliance.
3. Check Motor Pulley: Spin the motor pulley manually. If the pulley doesn’t spin freely, it suggests an issue with the drive motor, and it should be replaced.
4. Inspect Drive Pulley on Washer Tub: Rotate the large drive pulley on the back of the washer tub. If it doesn’t spin freely, this could indicate a problem with the spin bearing. In such cases, replacing the outer tub and spin basket is often necessary due to a failed spin bearing.
5. Assess Spin Bearing: If the spin bearing appears to be in good condition (spins freely), proceed to check the resistance of the motor windings. A proper reading should fall between 4 and 6 ohms.
6. Motor Windings Resistance Check: Using a multimeter, measure the resistance of the motor windings. If the reading is outside the 4-6 ohms range, the motor may have failed and requires replacement.
7. Speed Control Board Inspection: If the motor is in good condition, the issue may lie with the speed control board. In such cases, replacing the speed control board is usually the solution.

By systematically following these steps, you can identify and address the root cause of Frigidaire Washer Error Code E56 related to high motor current. Keep in mind that if you encounter difficulties or the problem persists, it’s advisable to seek professional assistance for a thorough diagnosis and precise resolution.