Frigidaire Washer Error Code E35

If your Frigidaire washer is equipped with a digital display and you’re encountering Error Code E35, it indicates a potential overfill situation. This error is specific to models featuring a digital display panel.

Here’s a detailed breakdown of the issue and possible solutions:

1. Cause of Error:

• The water-level pressure sensor has detected an overfill condition.

2. Diagnostic Steps:

• Check if the washer is genuinely overfilling. Inspect the inlet water fill valves to ensure they are effectively shutting off the water flow during the fill cycle.
• If the inlet water fill valves are defective and not stopping the water flow, consider replacing the entire water inlet valve assembly.

3. Troubleshooting:

• If the washer is not overfilling but still displays Error Code E35, the water-level pressure sensor is likely malfunctioning and may need replacement.

Steps to Resolve:

a. Inspect Inlet Water Fill Valves: – Ensure that the inlet water fill valves are closing properly. – If defective, replace the water inlet valve assembly.

b. Replace Water-Level Pressure Sensor: – If the washer isn’t overfilling but the error persists, the water-level pressure sensor may be faulty and should be replaced.

Additional Tips:

• Before initiating any repairs, it’s advisable to disconnect the washer from the power source and water supply.
• Refer to the user manual for specific instructions related to your washer model.

Conclusion: Frigidaire Washer Error Code E35 points to a potential overfill issue, requiring a careful examination of the water fill valves and the water-level pressure sensor. By following the outlined diagnostic steps and troubleshooting procedures, you can identify and address the underlying cause, ensuring your washer operates seamlessly once again. If uncertainties persist, consider seeking professional assistance for a thorough inspection and resolution.